Hitachi HTS725050A9A364 Datasheet download pdf (Page 39)

7K500 OEM SPECIFICATION

Page 39 of 176

7 7

7 Electrical interface specifications

Electrical interface specificationsElectrical interface specifications

Electrical interface specifications

7.1

7.17.1

7.1 Cabling

CablingCabling

Cabling

The maximum cable length from the host system to the hard disk drive plus circuit pattern length in the

host system shall not exceed 1 meter.

7.2

7.27.2

7.2 Interface connector

Interface connectorInterface connector

Interface connector

The figure below shows the physical pin location.

Figure 3. Interface connector pin assignments



All pins are in a single row, with a 127 mm(.050”) pitch.



The comments on the mating sequence in Table in the section 7.3 apply to the case of back-plane

blind-mate connector only. In this case, the mating sequences are:(1)the ground pins P4 and P12;(2)

the pre-charge power pins and the other ground pins; and (3) the signal pins and the rest of the

power pins.



There are three power pins for each voltage. One pin from each voltage is used for pre-charge in the

backplane blind-mate situation.



If a device uses 3.3V, then all V33 pins must be terminated. Otherwise, it is optional to terminate any

of the V33 pins



If a device uses 5.0V, then all V5 pins must be terminated. Otherwise, it is optional to terminate any

of the V5 pins



If a device uses 12.0V, then all V12 pins must be terminated. Otherwise, it is optional to terminate

any of the V12 pins.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 175 176

No comments

Hitachi HTS725050A9A364 Datasheet Page 39