Hitachi P50A402 User Manual download pdf (Page 2)

Important Safety Instructions

To the CATV system installer: This reminder is provided

to call the CATV system installer’s attention to Article 820-

44 of the NEC that provides guidelines for proper grounding and, in

particular, species that the cable ground shall be connected to the

grounding system of the building, as close to the point of cable entry

as practical.

SAFETY POINTS YOU SHOULD KNOW ABOUT YOUR HITACHI PLASMA TELEVISION

Our reputation has been built on the quality, performance, and ease of service of Hitachi plasma televisions.

Safety is also foremost in our minds in the design of these units. To help you operate these products properly, this section illustrates safety

tips which will be of benet to you. Please read it carefully and apply the knowledge you obtain from it to the proper operation of your Hitachi

plasma television.

Please ll out your warranty card and mail it to Hitachi. This will enable Hitachi to notify you promptly in the improbable event that a safety

problem should be discovered in your product model. Model and serial numbers are indicated on back side and right side of the plasma

television.

The lightning ash with arrowhead symbol, within an equilateral

triangle, is intended to alert the user to the presence of uninsulated

“dangerous voltage” within the product’s enclosure that may be of a

sufcient magnitude to constitute a risk of electric shock to a person.

The exclamation point within an equilateral triangle, is intended to

alert the user to the presence of important operating and maintenance

(servicing) instructions in the literature accompanying the appliance.

NOTE

READ BEFORE OPERATING EQUIPMENT

Follow all warnings and instructions marked on this plasma

television.

Read these instructions.1.

Keep these instructions.2.

Heed all warnings.3.

Follow all instructions.4.

Do not use this apparatus near water.5.

Clean only with a dry cloth.6.

Do not block any ventilation openings. Install in accordance 7.

with the manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat

registers, stoves, or other apparatus (including ampliers) that

produce heat.

Do not defeat the safety purpose of the polarized or grounding-

type plug. A polarized plug has two blades with one wider

than the other. A grounding type plug has two blades and

a third grounding prong. The wide blade or the third prong

are provided for your safety. If the provided plug does not t

into your outlet, consult an electrician for replacement of the

obsolete outlet.

Protect the power cord from being walked on or pinched

10.

particularly at plugs, convenience receptacles, and the point

where they exit from the apparatus.

Only use the attachments/accessories specied by the

11.

manufacturer.

Use only with the cart, stand, tripod, bracket, or

12.

table specied by the manufacturer, or sold with

the apparatus. When a cart is used, use caution

when moving the cart/apparatus combination to

avoid injury from tip-over.

Unplug this apparatus during lightning storms or when unused

13.

for long periods of time.

Refer all servicing to qualied service personnel. Servicing

14.

is required when the apparatus has been damaged in any

way, such as power-supply cord or plug is damaged, liquid

has been spilled or objects have fallen into the apparatus, the

apparatus has been exposed to rain or moisture, does not

operate normally, or has been dropped.

Televisions are designed to comply with the recommended

15.

safety standards for tilt and stability. Do not apply excessive

pulling force to the front, or top, of the cabinet which could

cause the product to overturn resulting in product damage

and/or personal injury.

Follow instructions for wall, shelf or ceiling mounting as

16.

recommended by the manufacturer.

An outdoor antenna should not be located in the vicinity of

17.

overhead power lines or other electrical circuits.

If an outside antenna is connected to the receiver be sure the

18.

antenna system is grounded so as to provide some protection

against voltage surges and built up static charges. Section

810 of the National Electric Code, ANSI/NFPA No. 70-1984,

provides information with respect to proper grounding for the

mast and supporting structure, grounding of the lead-in wire

to an antenna discharge unit, size of grounding connectors,

location of antenna discharge unit, connection to grounding

electrodes and requirements for the grounding electrode.

Power source

This plasma television is designed to operate on 120 volts 60 Hz, AC current. Insert the power cord into a 120 volt 60 Hz outlet. The mains

plug is used as the disconnect device and shall remain readily operable.

To prevent electric shock, do not use the plasma television’s (polarized) plug with an extension cord, receptacle, or other outlet unless the

blades and ground terminal can be fully inserted to prevent blade exposure.

Never connect the plasma television to 50 Hz, direct current, or anything other than the specied voltage.

Caution

Never remove the back cover of the plasma television as this can expose you to very high voltages and other hazards. If the

television does not operate properly, unplug the plasma television and call your authorized dealer or service center.

Adjust only those controls that are covered in the instructions, as improper changes or modications not expressly approved by

Hitachi could void the user’s warranty.

1 2 3 4 5 6 7 ... 61 62

Comments to this Manuals

No comments

Hitachi P50A402 User Manual Page 2

Comments to this Manuals

Related products and manuals for Televisions Hitachi P50A402