Hitachi P50A402 User Manual download pdf (Page 12)

Quick Setup Guide

Perform the following steps to quickly setup your new

Hitachi Plasma Television Set.

1. ANTENNA CONNECTION

Unless your Plasma Television is connected to a cable TV system

or to a centralized antenna system, a good outdoor color TV

antenna is recommended for best performance. However, if you

are located in an exceptionally good signal area that is free from

interference and multiple image ghosts, an indoor antenna may be

sufcient.

VHF (75-Ohm) antenna/CATV (Cable TV)a).

When using a 75-Ohm coaxial cable system, connect CATV

coaxial cable to the AIR/CABLE (75-Ohm) terminal. Or if you have

an antenna, connect the coaxial cable to the same AIR/CABLE

terminal.

To outdoor Antenna

Cable TV (CATV)

System

To Antenna

Terminal

VHF (300-Ohm) antenna/UHF antennab).

When using a 300-Ohm twin lead from an outdoor antenna,

connect the VHF or UHF antenna leads to screws of the VHF or

UHF adapter. Plug the adapter into the antenna terminal on the

TV.

To outdoor VHF or

UHF Antenna

To Antenna

Terminal

Connecting a 300-Ohm twin lead connector may cause interference. Using a 75-Ohm coaxial cable is recommended.

NOTE

Rear Panel Jack

Antenna Terminal

Connect the power cord to your TV set and secure it a).

with the cable tie (see page 7) .

Connect the power cord to the AC Wall outlet .b).

When both VHF and UHF antennas are connectedc).

Attach an optional antenna cable mixer to the TV antenna terminal,

and connect the cables to the antenna mixer. Consult your dealer

or service store for the antenna mixer.

To outdoor antenna

or CATV system

To UHF antenna

Antenna Mixer

Air/Cable

The Indicating Lamp will light Red (Standby mode) and c).

then light blue (image displays).

2. CONNECT YOUR NEW HITACHI PLASMA TV TO THE POWER SOURCE

3. POWER ON/OFF YOUR NEW HITACHI PLASMA TV.

Press the POWER button on the Remote Control or the

POWER switch on the Side Control Panel for power on/off

(Stand-By mode).

4. FOLLOW THE TV SETUP WIZARD INSTRUCTIONS ON NEXT PAGE.

Air/Cable

POWER

CURSOR

V OL

INPUT/ EXIT

/ SELECT

For Stand-By

Power OFF

Indicating

Lamp

If the Power Switch is set to OFF, the Power Button

on the Remote Control will not operate.

NOTE

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 61 62

Comments to this Manuals

No comments

Hitachi P50A402 User Manual Page 12

Comments to this Manuals

Related products and manuals for Televisions Hitachi P50A402