Hitachi L42X01AU User Manual download pdf (Page 18)

CONNECTION (continued)

Connecting Procedure (continued)

1.Connecting Power Cord to Rear Panel.

Connect power cord to the television.

* Make sure not to connect the power plug to the wall socket

until all connections are completed.

2.Connecting Aerial Lead.

There are two ways to connect aerial lead.

When you do not have any other external equipment

Connect the aerial lead directly into the socket at rear

panel.

When you have one or more external devices to

connect:

1. Use RF cable to connect between each equipment and

aerial.

2. Connect the Aerial Lead to an equipment ”In” socket

marked

3. Connect the RF cable from the equipment “Out” to the

other equipment “In”.

4. Then, connect from the equipment ”Out” to “ANT” on the

LCD screen socket.

[Example: Connecting Antenna through STB

and VCR.]

Precautions when connecting the aerial

Please use a coaxial cable which is free from interference to connect the aerial. Avoid using a parallel flat feeder

wire as interference may occur, causing reception to be unstable and stripe noise to appear on the screen.

Avoid using indoor aerial as this may be affected by interference. Please use CATV net or outdoor aerial.

For safety, install an external aerial conforming to AS1417.1( Applicable for Australia only)

If there are noise in the picture of VHF-Low band channel, please use the double-shielded cable (not provided) for

RF LEADS to reduce the noise.

STB

VCR

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

No comments

Hitachi L42X01AU User Manual Page 18