Hitachi LE32H405 User Manual download pdf (Page 20)

Connections to other equipment (continued)

To connect a HDMI or a DVI device to the unit

The HDMI/DVI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital video from a DVI

device.

When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only video signal. Separate analog audio cables are

required.

Back of the unit

To PC/DVI AUDIO IN

RGB/_AUDIO.D.I1/ovl

,"--J RGB I

Audio cord (not supplied)

To DVI output

HDMI - to - DVl adapter cable

(HDMI type A connector) (not supplied)

To HDMI/DVI IN or

HDMI cable (type A connector) (not supplied)

To HDMI out

DVI device

HDMI device

When using a HDMI input from a Set-Top-Box, it is recommended to use a 1080p, 1080i or 720p input signal.

When the HDMI input is a 1080p signal, it is recommended that the length of the cable should be less than 5 meters.

Using an AV Amplifier with built-in digital surround

If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including Dolby Digital Surround

audio that sounds just like the movie.

Connect an AV amplifier with built-in Dolby Digital decoder, DTS decoder, or MPEG decoder etc. as shown below.

Rear of the unit

DIGITALOUT(COAXIAL)

COAXIAL OUT

Coaxial digital cable---_

(not supplied)/

To Coaxial_ I

Digital Audio Inputq

AV A_ i:_,_t __-'On _-gi_als_--_urround_

decoder as listed above

Front Speak-

Subwoofer er (Right)

(Left)Fr°ntFL_\ _\_ _. TV _/__o

Speaker _ \ (_\

\ Center Speaker

_ Surround _ SurroundSpeaker (Left) Speaker (Right)

len you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio. There will be no sound

output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder..

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Hitachi LE32H405 User Manual Page 20