Hitachi CP-X10000 User Manual download pdf (Page 20)

Operating

Turning off

Press the STANDBY/ON button again while the

message is shown.

The projector lamp will go off, and the POWER

indicator will begin blinking in orange.

Then the POWER indicator will stop blinking

and light in steady orange when lamp cooling is

complete.

After making sure that the POWER indicator lights in steady orange, and

press down the side marled “O” on the power switch.

The POWER indicator will go off.

• Use the shutdown switch only when the projector can be not turned

off by normal procedure.

NOTE

►Do not approach the lamp cover and the exhaust vents for a

while after the lamp goes out, since they may be hot and could cause burns.

WARNING

►Turn your device off prior to the projector, except for the cases

directed by the manuals of devices.

NOTICE

The following walks you through the steps to turn the projector off.

For other devices, follow the manual of each.

Press the STANDBY/ON button on the projector

or the remote control.

The message "Power off?" will appear on the

screen for about 5 seconds.

STANDBY/ON

SHUTTER SECURITY LAMP TEMP POWER

STANDBY/ON

Using the elevator feet

Lengthening or shortening the length of the elevator feet shifts the projection

position and the projection angle.

Turn the elevator feet each to adjust their length

►Do not place the projector with an inclination of 5 degrees

or more. The projector leaned exceeding the limit could cause malfunction and

shorten the life of the projector.

CAUTION

5°

►Do not lengthen the elevator feet to 30 mm or more. The foot

lengthened exceeding the limit may come off and drop the projector down, and

result in an injury or damaging the projector.

WARNING

max.

30 mm

Power

switch

POWER indicator

STANDBY/ON button

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 77 78

Comments to this Manuals

No comments

Hitachi CP-X10000 User Manual Page 20

Comments to this Manuals

Related products and manuals for Projectors Hitachi CP-X10000