Hitachi CP-X10000 User Manual download pdf (Page 19)

Operating

Make sure that the power cord is rmly and

correctly connected to the projector and the outlet.

Press down the side marked “I” on the power

switch.

The POWER indicator will light up in steady

orange.

Then wait for the buttons to become ready. It may

take several seconds

Press the STANDBY/ON button (on the projector

or the remote control).

The projection lamp will light up and the POWER

indicator will begin blinking in green. When the

power is completely on, the indicator will stop

blinking and light in steady green.

To display the picture, select an input signal according to the section "Displaying

and switching the image" (

22).

Turning on

The following walks you through the steps to turn the projector on. For other

devices, follow the manual of each.

• When the item DIRECT ON of the OPTION menu is set to the ON,

and that the projector was turned off by only the power switch without using

the STANDBY/ON button, switching the power switch on turns the projector on

without the formal procedure shown above.

NOTE

►Do not look directly into the lens or the openings on the

projector while the lamp is on.

►Do not approach the lamp cover and the exhaust vents, while the projection

lamp is on.

WARNING

►Do not turn your device on prior to the projector, except for the

cases directed by the manuals of devices.

NOTICE

STANDBY/ON

SHUTTER SECURITY LAMP TEMP POWER

STANDBY/ON

Power

switch

POWER indicator

STANDBY/ON

button

Operating

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 77 78

Comments to this Manuals

No comments

Hitachi CP-X10000 User Manual Page 19

Comments to this Manuals

Related products and manuals for Projectors Hitachi CP-X10000