Hitachi Projector CP-X328 User Manual download pdf (Page 14)

Remove the battery

cover

Slide back and remove

the battery cover in the

direction of the arrow.

Insert the batteries

Align and insert the two AA

batteries (that came with the

projector) according to their plus

and minus terminals (as indicated

in the remote control).

Close the battery

cover

Replace the battery cover

in the direction of the arrow

and snap it back into place.

•

The remote control works with both the

projector's front and rear remote sensors.

•

The range of the remote sensor on the front and

back is 3 meters with a 60-degree range (30

degrees to the left and right of the remote sensor).

•

Since the remote control uses infrared light to send

signals to the projector (Class 1 LED), be sure to

use the remote control in an area free from

obstacles that could block the remote control's

output signal to the projector.

approximately

3 meters

approximately

3 meters

30 degrees

2 3

USING THE REMOTE CONTROL

CAUTION

Precautions to observe in regards to the batteries

Always handle the batteries with care and use them only as directed. Improper use may result in

battery cracking or leakage, which could result in fire, injury and/or pollution of the surrounding environment.

• Keep the battery away from children and pets.

•

Be sure to use only the batteries specified for use with the remote control. Do not mix new batteries with used ones.

•

When inserting batteries, verify that the plus and minus terminals are aligned correctly (as indicated in the remote control).

• When you dispose the battery, you should obey the law in the relative area or country.

Precautions to observe when using the remote control

• Do not drop or otherwise expose the remote control to physical impact.

•

Do not get the remote control wet or place it on wet objects. Doing so may result in malfunction.

• Remove the batteries from the remote control and store them in a safe place if you

won't be using the remote control for an extended period.

• Replace the batteries whenever the remote control starts to malfunction.

•

When strong light, such as direct sunlight or light from an extremely close range (such as from an

inverter fluorescent lamp), hits the projector's remote sensor, the remote control may cease to function.

Adjust the direction of the projector to keep light from directly hitting the projector's remote sensor.

ATTENTION

Putting batteries into the remote control unit

Operating the remote control

CP-S317/327W/最終 03.5.27 2:22 PM ページ 13

Downloaded from www.Manualslib.com manuals search engine

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 52 53

Comments to this Manuals

No comments

Hitachi Projector CP-X328 User Manual Page 14

Comments to this Manuals

Related products and manuals for Data projectors Hitachi Projector CP-X328