Hitachi CP-S840W/E User Manual download pdf (Page 31)

ENGLISH

Replace the lamp with new one and

fix it using the same two screws.

· Firmly tighten the lamp screws. Loose screws may cause

bad connection of the connector which in turn may result

in malfunctioning.

Screw

Lamp

Install the lamp cover and fix it using screws.

· To prevent burn, install the lamp cover and secure it using the screws.

· Do not turn on the power with lamp cover removed.

Lamp (continued)

Please carry out the following operation within 10 minutes from power on, if you replaced the lamp after

2,000 hours.

2. Reset the lamp time

POSITION ON

OFF

LASER

RESET

MOUSE ON

BLANK TIMER

RGB VIDEO

INPUT

MENU ON

RIGHT

VOLUME

MAGNIFY

1, 2

1) Press the RESET button on projector for 3 seconds or remote control TIMER

button for 3 seconds and display the total lamp used time.

· When accumulated operation time of the lamp reaches 1500 hours, the

following display will appear at the bottom of the screen.

2)Press the RESET button on projector or remote control MENU ON button

during displaying the lamp used time.

3) Select the “0” on the screen using the MENU ( ) button or DISK PAD.

LAMP 1500 □ 0 ■CANCEL

LAMP 1500 h

¬

· Whenever the lamp is replaced, reset the total operation time of the lamp. Do not reset if the lamp has not

been replaced.

· Do not perform resetting without changing the lamp, as this can cause lamp breakage.

Lamp cover

Screw

RESET

MUTE

INPUT

STANDBY/ON

1 2 ... 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

Hitachi CP-S840W/E User Manual Page 31

Comments to this Manuals

Related products and manuals for Data projectors Hitachi CP-S840W/E