Hitachi L47S601 User Manual

LCD Flat Panel TELEVISIONOperating Guide for L47S601 & L42S601IMPORTANT SAFETY INSTRUCTIONS ...

10First time useQuick Reference Remote Control Buttons and FunctionsIn addition to controlling all of the functions on your HITACHI LCD TV, the new re

11First time useFRONT VIEWSIDE PANELCONTROLS Side Panel ControlsPress this button to turn the LCD TelevisionON/OFF. It can also be

12First time useREMOTE CONTROL sensorPoint your remote at this area when selectingchannels, adjusting volume, etc.INPUT- FRONT JACKSINPUT- FRONT provi

13First time useRear Panel Connections Antenna InputTo switch between Cable and Air input, go to theChannel Manager option to change the signal

14First time useThe SIDE panel jacks are provided as a convenience to allow you to easily connect HDMI or DVI signalsfrom a DVD, Set

15First time useThe SIDE panel jacks are provided as a convenience to allow you to easily connect a camcorder , DVD, VideoGame and a VCR as shown in t

16First time useNOTE: Cables are optional, except when specified.HDMI DIGITALOUTPUT CAPABILITY HDMI OUTPUTHDMItoHDMIVCR #1Cable TV coaxial cable2-Way

17First time useTips on Rear Panel Connections• S-VIDEO, Y-PBPR, or HDMI connections are provided for high performance laserdisc players, VCRs etc. th

First time use18Back ofVCROUTPUTVCRVideoCONNECTING A VIDEO AND STEREO AUDIOSOURCE TO INPUT1 ~ INPUT-FRONT1. Connect the cable from the VIDEO OUT of th

19First time useCONNECTING A COMPONENT SOURCE WITH HDMI ORDVI CAPABILITY TO HDMI 1, HDMI 2 OR HDMI FRONT1. Connect the HDMI or DVI to HDMI connectionc

Important Safety InstructionsSAFETY POINTS YOU SHOULD KNOW ABOUTYOUR HITACHI LCD FLAT PANEL TELEVISIONOur reputation has been built on the qual

20First time useCONNECTING A COMPONENT AND STEREOAUDIO SOURCE TO INPUT 2 or 3 :Y-PBPR.1. Connect the cable from the Y OUT of theLaserdisc/DVD

21First time useCONNECTING A VIDEO AND MONAURAL AUDIOSOURCE TO INPUT 1 ~ FRONT INPUT1. Connect the cable from the VIDEO OUT of theVCR or the laserd

22The Remote ControlIn addition to controlling all the functions on yourHitachi LCD TV, the new remote control isdesigned to operate different

3Important Safety InstructionsPower sourceThis LCD television is designed to operate on 120volts 60 Hz, AC current. Insert the power cord into a12

CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics o

A51. Using metallic wire (two places) fasten the set tothe clamping screw on the rear of the LCD FlatPanel TV as shown below.Securing to

Pass the AC cord through Clamp #1 and connectThe AC cord, power swivel cable and the signalcables can all be held together with Clamp #2.AC

7SETTING FOR WALL MOUNTINGSTEP (1) :Please locate the STAND METAL SUPPORTS on the back of the TV . These metals is use to hold the TV and the Base ;so

8First time useHow to set up your new HITACHI TelevisionVIEWINGThe best picture is seen by sitting directly in front ofthe TV and about 10 to 18 feet

9First time use300-Ohm Twin Lead This outdoor antenna cable must be connected to anantenna adapter (300-Ohm to 75-Ohm).Phono or RCA Used on all sta