Hitachi VM-1700A User Manual download pdf (Page 49)

VIEWING THE PICTURE PLAYED BACK ON YOUR TV

NOTE: When noise appears in the played back picture, adjust "TRACKING" control on the

VCR so there is no noise.

Example 3: If your TV is a regular TV,

Diagram of Hookup

1. Disconnect the VHF antenna leads from the rear of the TV receiver.

NOTE: Leave the UHF antenna leads connected to the TV.

2. Connect the VHF antenna lead to "IN FROM ANT" on the RF converter unit. If the

cable is round (75 Ohm), it will connect directly to the "IN FROM ANT". If it is the flat

type, (300 Ohm), connect it to the antenna adaptor (300 Ohm to 75 Ohm) and slip the

adaptor on to the "IN FROM ANT" terminal.

3. Connect the 75 Ohm coaxial cable with antenna adaptor to "OUT TO TV" on the RF

converter unit.

4. Connect the other end to the VHF antenna terminal on the TV, as illustrated.

5. Connect the connector cable from RF converter unit to "RF DC OUT", "AUDIO", and

"VIDEO" jacks on the camcorder.

6. Turn on the TV and set to channel 3 unless channel 3 is one of the TV stations in

your area. If channel 3 is used in your area, set your TV to channel 4.

7. Set the RF channel selector on the RF converter unit to "CH3" or CH4" to match the

channel selector on your TV.

8. Perform same procedures in steps 4 through 7 of "Example 1".

NOTE: If you want to watch a TV program with camera/recorder connected as illustrated,

slide "POWER" switch of the camera/recorder to "OFF".

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 67 68

No comments

Hitachi VM-1700A User Manual Page 49