Hitachi 42V525 User Manual download pdf (Page 10)

REAR PANEL JACKS

 Antenna Input/Output

The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can

be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be displayed as a

sub-picture.) The antenna output labeled “TO CONVERTER” allows the ANT A connection to pass directly to a different source

such as a cable box, only when ANT B is displayed as a main picture.

 Audio/Video Inputs 1, 2, 3 and 4

By using the INPUTS button and CURSOR buttons of the remote control you can select each video source. Use the audio and video

inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (If you have mono sound, insert

the audio cable into the left audio jack.)

 MONITOR OUT

These jacks provide fixed or variable audio and video signals which are used for recording. Use the S-VIDEO Output for high

quality video output (see page 65).

 S-VIDEO Inputs 3 and 4

Inputs 3 and 4 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.

 Component: Y-P

Inputs

Inputs 1 and 2 provide Y-P

jacks for connecting equipment with this capability, such as a DVD player or Set Top Box. You may

use composite video signal for both inputs.

NOTE: You may use VIDEO or S-VIDEO inputs to connect to INPUT 3 and 4, but only one of these inputs may be used at a

time.













CONVERTER

12345



ANT B

ANT A

S-VIDEO

VIDEO

AUDIO

(MONO)

(MONO) (MONO) (MONO)

VIDEO

MONITOR OUT INPUT 4 INPUT 3

INPUT 2 INPUT 1

HDMI 1

RS232C

AUDIO

TO HI-FI

TV AS CENTER

NOTES: 1. Do not connect composite VIDEO and S-VIDEO to Input 3, 4 or 5 at the same time. S-VIDEO has priority

over VIDEO input.

2. Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to

the TV’s P

input and the components R-Y output to the TV’s P

input.

3. Your component outputs may be labeled Y-C

. In this case, connect the component C

output to the TV’s

input and the component C

output to the TV’s P

input.

4. It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-P

inputs (see page 38).

5. To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-P

jacks.

6. Input 1 and Input 2 (Y/VIDEO) can be used for composite video and component video input.

FIRST TIME USE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 75 76

Comments to this Manuals

No comments

Hitachi 42V525 User Manual Page 10

Comments to this Manuals

Related products and manuals for Projectors Hitachi 42V525