Hitachi 42PD5000 User Manual download pdf (Page 58)

Be sure to insert the speaker cables securely.

Lock the connection terminal level securely.

Caution required

Caution

Make sure the monitor power is switched off (with the standby/ receive lamp switched off or red)

before you connect or disconnect the speaker cables.

Attach the speaker systems to the monitor.

Attach the speaker brackets to the speaker systems.

Attach the screws in a position that allows you to read the speaker holder orientation markers (R), (L).

screw X 2

Speaker holder

Speaker

holder

(R)

In the case of (R)

(L)

Cushion

SPEAKER TERMINAL

Ω

8W)

Loosen

screws

Monitor rear side

Hook this section

on the loosened

screw

Speaker holder

shown the other side

Remove

screws

Remove

screws

スピーカー端子

(6Ω12W )

Right side

Remove two screws on each side of the monitor

as shown and keep them for re-install. Loosen

two screws on each side of the monitor as

shown so that the speaker holders can be slide

on to them. Insert the loosened screws into the

engaging holes of the speaker holders that are

attached to the speaker system, and slide the

screws downwards. Next, use the previously-

removed screws to fasten the speaker holders

into the mounting holes in the monitor. Tighten

the four screws to secure.

Attach the speaker systems to the monitor.

Attach the connection cables to

the speaker system.

Connect the copper-coloured

wire to the side

Connect the silver-coloured

wire to the side

Speaker terminals

Press down

the lever with

your finger

Remove

your finger

Insert the

wire

How to connect

the speaker

cables

(Speaker side)

Pull off while twisting

Please prepare the supplied

speaker cables.

Treating the wire ends

Attach the speaker connection

cables to the monitor.

スピーカー端子

(6Ω12W )

スピーカー端子

(6Ω12W )

Black Red

Connect

the copper-

colour wire

（）

Connect

the silver-

colour wire

（）

スピーカー端子

(6Ω12 W )

How to connect

the speaker

cables

(Monitor side)

Press the

lever down

Raise the

lever

Insert the

wire

Use of cushions

In some cases, there can

be a gap between the main

unit and the speaker. You

can attach the cushions

provided to the side of the

speaker system, if desired,

to eliminate the gap.

Attach the cushions

to the sides of the

speakers facing the

main unit.

Cushion

Align the cushions

to the front of the

back case and affix

them.

Back case

Notice

00 42型スピーカー統合-五校 03.9.9 3:39 PM ページ2

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 75 76

Comments to this Manuals

No comments

Hitachi 42PD5000 User Manual Page 58

Comments to this Manuals

Related products and manuals for Plasma TVs Hitachi 42PD5000